Anca SYS32
- Anca SYS32
Anca SYS32
Grease Lubrication
Tool & Cutter grinding spindle
The grease was completly washed from the bearings by part coolant causing the bearings to fail.
We remanufactured the front labyrinth and replaced the open bearings with a sealed bearing design. By incorporating these contamination prevention design upgrades their spindles have been lasting at least 3 to 4 times longer than before the upgrade. Their spindle life is now measured in years instead of months.
- Anca RGX
Anca RGX
This spindle failed from contamination and had 8 microns run out on the taper. Our incoming evaluation showed the contamination was entering through the rear of the spindle. We reworked the rear of the spindle to keep the same functionality but remove the possibility of contamination entering the spindle. We kiss ground the taper and assembled the spindle.
- Anca MG7
Anca MG7
Tool & Cutter grinding spindle
This spindle failed from coolant contamination and had 10 microns of run out in the taper. We kiss ground the taper on one of our Kellenburger ID/OD grinders and assembled the spindle. Our outgoing QC showed less than a micron of run out on the taper.
- Anca TG7 Spindle
Anca TG7 Spindle
Used for tool and cutter grinding
-
This is one type of Anca spindle we repair for many of our tool and cutter manufacturing accounts. The most common cause of failure is contamination. We pay special attention to the front labyrinth on the spindle to make sure it is giving you the best contamination protection possible.