Setco 4003Y
- Setco 4003Y
Setco 4003Y
3,500 rpm
Thread repair
Our customer runs several of these spindles and has been for decades. Eventually the threads for the tool holder wear out. We are able to fix this problem for them with out the cost of manufacturing a new shaft. This can be done on most spindle models. It is a fairly common problem on surface grinding spindles.
- GMN TS80CX142 Walter Spindle
GMN TS80CX142 Walter Spindle
10,000 rpm
HSK style OD tapers
Tool & Cutter grinding spindle
This spindle had worn bearings and 3 to 4 microns of run out on the tapers. We are able to fix these spindles because we have our in house grinding department. The tooling interfaces need to meet micron tolerances to function properly. We have developed a process and the equipment needed to meet these tolerances.
We repair all types of Walter Grinder spindles from older style to the newest release.
- GMN TS60X148
GMN TS60X148
Haas Universal Grinder Spindle
Saw Blade Sharpening Spindle
This GMN spindle fits a Haas Universal Grinder. We have done several of this type of spindle for our customers. They are belt driven and grease lubricated. If you are experiencing part quality issues or poor spindle performance call Northland Tool & Electronics.
- Pope F88-5388
Pope F88-5388
Grinding spindle
This spindle needed fresh bearings and kiss grinds to both tapers to bring it back to optimum performance levels. We were able to repair this spindle in less than two days for our customer because we have our on site grinding department with two Kellenburger ID/OD grinders. We do not grind spindles in assembly like a lot of our competition. That is a sure sign of poor workmanship being hidden by poor repair practices.
Setco 4204BY
Setco 4204BY
10,000 rpm
Spindle was contaminated with coolant. We reviewed the air purge specifications with our customer and found that they were not set properly on the machine. We repaired the spindle gave the technical assistance needed for the air purge and this should result in a long cycle life of the spindle.
- Setco Block Spindle
Setco Block Spindle
3600 rpm
Used for the manufacture of drill bits this spindle is subjected to large amounts of oil splashing on the front of the spindle. The primary cause of failure was coolant contamination. We worked with our customer and through our spindle care training program were able to reduce their spindle repair expenditures by 53%.
- Anca TG7 Spindle
Anca TG7 Spindle
Used for tool and cutter grinding
-
This is one type of Anca spindle we repair for many of our tool and cutter manufacturing accounts. The most common cause of failure is contamination. We pay special attention to the front labyrinth on the spindle to make sure it is giving you the best contamination protection possible.
- Walter Grinder Spindle
Walter Grinder Spindle Repair
With the changes at Walter Grinder Corp. getting your spindles repaired is more difficult than it used to be. Northland Tool & Electronics can help. We repair the full line of Walter Grinder spindles. We have our own grinding department to insure the HSK tooling interfaces are repaired to OEM specifications. Our repairs are much less expensive than exchanging or buying new. Call us for details. 800-774-6353.