Spindle Rebuild and Repair Testimonials

"This is Jeff Denyer with ComNav Engineering up here in Maine. We sent a brown and sharp micromaster 618 spindle to you guys to be rebuilt. It is now installed and running perfect. We have 3 other grinders like this with the original spindles in them. If we have any more go bad then we will send them to you guys, we also have a fanuc robodrill and a hass turning center. Just wanted to let you guys know that you do a great job at a reasonable price and that we will be using you guys exclusively for all our rebuilds."

Jeff Denyer
Head Machinist

"When faced with an overly priced replacement spindle for we looked to Northland Tool for an alternative. The crew at Northland Tool gave us multiple options and based on our needs were willing to work with us on a creative solution. With a friendly, knowledgeable staff, outstanding quality and great turnaround time Northland Tool had us back up and running within a day."

BJ Lannigan
Deka Research
Manchester New Hampshire

"We are a large supplier to the automotive industry and we use several Bryant Grinders in our manufacturing process. Over the years we have tried a few different spindle rebuilders but always felt we were being taken advantage of. None of our spindles that failed prematurely were covered under warranty and our repair costs were rising dramatically.

We were referred to Northland Tool & Electronics and from the first phone conversation we knew we were on the right track to solving our spindle failure problems. The knowledgeable staff reviewed each repair and recommended procedures to implement in our process. Northland even supplied additional information and checks to perform during the installation process to insure the spindle was supported properly with coolant, lubrication and electrically.

Within 6 months Northland Tool reduced my spindle repair expenditures by 63%. "

Mike B.