Give us a call 800-774-6353. Performing a Grind Plate Grind to your drawbar shaft in most cases is a lower cost alternative than replacing it with new. Over time the belleville washers or coil springs can wear grooves in the drawbar shaft itself. This can cause poor tool retention force and difficulty getting full travel of the drawbar during tool changes.
Running this spindle too long caused deformed ball bearings and damage to the outer race
Damage to the outer race is consistent with prolonged operation after spindle exhibited initial signs of needing to be rebuilt
Every spi…
Read MoreWhen a cylindrical surface, such as the OD of a shaft or the ID of a tooling taper, becomes worn or damaged, we use a process referred to as grind-plate-grind (GPG) to restore dimensions to original OEM specification.
Read MoreCONTACT YOUR SPINDLE REBUILDING SPECIALISTS TODAY AT 1.800.774.6353
GET A QUOTE EMERGENCY REPAIR SEND US YOUR SPINDLE