Okuma HK307 Spindle With Endplay



CHALLENGE

Spindle shaft had endplay incoming Front & rear bearings feel rough. Front shaft nut spanner holes are damaged. Shaft tooling pilot worn & tapered +5/+22µ and has 8µ runout.

SOLUTION

Clean, inspect overall dimensions. Repair front shaft nut spanner holes. Grind, chrome plate & finish grind shaft tooling pilot. Replace bearings, o-rings, air fittings & screws. Adjust preload, balance, assemble and break in. Final quality control inspection.

Does your spindle need repair? GET A QUOTE TODAY