Chevalier 1418 VMC with excessive run out



CHALLENGE

Possible cause of failure: Customer observed .002'' tool rock, but indicated no tool runout. Shaft taper is very worn with poor contact and 10-14µ runout. Drawbar gripper fingers are very worn, incoming retention force was 300lbs

SOLUTION

Recommended action: Clean, inspect overall dimensions. Kiss grind BT-30 shaft taper Replace bearings, grippers & bellevilles.

Does your spindle need repair? GET A QUOTE TODAY

More Case Studies

Repair History - Here are examples of similar spindle repairs that may contain additional information that will help you. If you have additional questions, please contact us.