Catastrophic bearing failure was the main cause of this spindle malfunction Continue reading to learn how Northland Tool performed this repair and converted a Weiss GHK 176239 spindle from grease-injected to permanent grease lubrication……Read More
Schneider CCP Swift Spindle Repair
The Schneider CCP Swift spindle is grease lubricated, pulley driven, and capable of running up to 750 rpm. This spindle is used in the optical polishing industry for precision lens manufacturing.
This Schneider CCP Swift spindle arrived at our facility for a full breakdown and evaluation. Upon inspection, we noted that the spindle was heavily contaminated with polishing slurry. The graphite piston was destroyed and would no longer allow proper actuation. No dimensional deviations were noted for this repair.
The following actions were performed on this Schneider CCP Swift spindle:
- Clean, inspect overall dimensions
- Replace bolts, o-rings, bearings, seals, and graphite piston
After reassembly of all components, adjusting bearing preload, and undergoing break-in and testing procedures, this spindle passed our final quality inspection before being returned to our customer with a 1-year warranty.
Does your spindle need repair? GET A QUOTE TODAY
Schneider CCP 103 Spindle Repair
Optics polishing spindles typically come to us covered in hardened, white polishing slurry. Some minor particulate contamination was discovered in the spindle interior. The graphite… [...]
Schneider CCP Modulo Spindle Repair
Our customer sent in this Schneider CCP Modulo spindle stating that the “tool pot” was broken inside. When it arrived at Northland Tool and Electronics,… [...]
Schneider HSC Smart XP Spindle Repair
This spindle is used in the generation of the surfaces on ophthalmic lenses. It is similar to a lathe spindle in that it turns the… [...]
Schneider SLC-50 Spindle Repair
This Schneider SLC-50 was sent in due to it failing in the machine. Upon inspection, we noted that the bearings failed from severe oil contamination. … [...]
Schneider SLG-120 Spindle Repiar
This Schneider SLG-120 spindle was noisy when spun by hand incoming. After disassembly and evaluation, we noted that the #4 bearing felt rough when spun… [...]
Running this spindle too long caused deformed ball bearings and damage to the outer race Damage to the outer race is consistent with prolonged operation after spindle exhibited initial signs of needing to be rebuilt Every spindle rebuilt by North…Read More