Catastrophic bearing failure was the main cause of this spindle malfunction Continue reading to learn how Northland Tool performed this repair and converted a Weiss GHK 176239 spindle from grease-injected to permanent grease lubrication……Read More
Okamoto Spindle Repair
Our customer sent Northland Tool and Electronics this spindle because it started making noise while operating. Unfortunately this customer has had a history of poor life from their Okamoto spindles. Northland Tool modifies the front of the spindle to accept a seal that will help protect the front bearings from coolant contamination. We have found this modification dramatically increases the spindles lifespan.
This Okamoto spindle suffered a catastrophic bearing failure due to front bearing contamination. The #1 bearing feels particularly rough compared to the rest. No dimensional deviations were noted for this repair.
The following actions were performed on this Okamoto spindle:
- Modify front cover for contamination seal
- Clean, inspect overall dimensions
- Replace bearings, bolts, and o-rings
After reassembly of all components, adjusting bearing preload, and undergoing break-in and testing procedures, this spindle passed our final quality inspection before being returned to our customer with a 1-year warranty.
Does your spindle need repair? GET A QUOTE TODAY
More Case Studies
Repair History - Here are examples of similar spindle repairs that may contain additional information that will help you. If you have additional questions, please contact us.
Okamoto OH-60M Spindle Repair
This Okamoto OH-60M spindle was difficult to rotate by hand incoming. Upon disassembly, we noted that the front shaft nut was loose and the spindle… [...]
Okamoto ACC-820DX Spindle Repair
This Okamoto ACC-820DX spindle was noisy when spun by hand incoming and had an extreme amount of rust and corrosion present on the nose of… [...]
Okamoto OH-30G Spindle Repair
On top of the excessive belt tension causing this Okamoto OH-30G spindle to fail, after disassembling and evaluating it we noted that the grease was… [...]
Okamoto Workhead Spindle Repair
The workhead spindle is often overlooked when spindle repair is being considered. The frequency of repair is certianly much less than the wheelheads but it is crucial to have a properly functioning wo [...]
Okamoto PSG-125 Spindle Repair
This Okamoto PSG-125 spindle was seized incoming and no tests could be performed. After a full breakdown and evaluation, we noted that the #3 bearing… [...]
Downtime is inevitable for any machine, but knowing how to reduce downtime or minimize its likelihood is critical.Read More